We use cookies and other tools to enhance your experience on our website and to analyze our web traffic.
For more information about these cookies and the data collected, please refer to our Privacy Policy.

why Resmed Airsense 10 Autoset SD card is not capturing data when the pressure increases or decreases beyond the set MIN and MAX limit

11 posts
bio
Was this reply useful? Learn more...
   
[-]
skvbksc321 +0 points · almost 2 years ago Original Poster

I would like to have clarification on why Resmed Airsense 10 Autoset SD card not capturing data when the pressure increases or decreases beyond the set MIN and MAX limit in Autoset Mode. Can anyone guide me on this topic for better clarification about the issue.

3,259 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · almost 2 years ago Sleep Patron

I am not quite sure what you question is. When you are in AutoSet Mode the pressure should stay between the MIN and MAX, unless EPR reduces it on exhale only. Are you using OSCAR to view the data? If so can you post a screenshot of the Daily results? On a PC just press F12 and take note where the image file is saved. Use File Explorer to find the file and then left click and drag it into an open message here.

11 posts
bio
Was this reply useful? Learn more...
   
[-]
skvbksc321 +0 points · almost 2 years ago Original Poster

Ok i will share screenshot with brief details

11 posts
bio
Was this reply useful? Learn more...
   
[-]
skvbksc321 +0 points · almost 2 years ago Original Poster

I have run the RESMED AIRSENSE 10 AUTOSET for 10 minutes, but it recorded in SD card for 4 minutes as shown in above image. Kindly help me by referring to below image and give some resolution.

3,259 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · almost 2 years ago Sleep Patron

I gather you are trying to test the AirSense 10 machine and this is not data from a real person?

If the machine is set with a minimum of 16 cm and max of 20 as it shows while in APAP mode I don't understand what would be reducing the pressure. I don't see the leak rate graph, but if the leak rate was really high perhaps the pressure would fall because the machine cannot produce enough flow to keep the pressure up. When the leak rate goes too high, some of the data display and event recording is suppressed.

It would be helpful if more data was allowed to show on the left panel. Under File, Preferences you can turn off the Event Breakdown Pie Chart. And by clicking on the black triangle beside the date you can suppress the full month calendar display. It also appears you have multiple sessions. There are red/green on off switches beside each session. You can turn off the sessions not of interest to get a little simpler display.

Please be advised that these posts may contain sensitive material or unsolicited medical advice. MyApnea does not endorse the content of these posts. The information provided on this site is not intended nor recommended as a substitute for advice from a health care professional who has evaluated you.