We use cookies and other tools to enhance your experience on our website and to analyze our web traffic.
For more information about these cookies and the data collected, please refer to our Privacy Policy.

resmed F30 mask

19 posts
Was this reply useful? Learn more...
   
[-]
wandafeb02 +0 points · about 5 years ago Original Poster

My resmed F30 mask leaks air from the nasal part. I feel air going up my upper face. I checked the "facial mask fit" and it shows that it is good. Should I be concerned?

3,161 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · about 5 years ago Sleep Patron

The short story is that if the mask leaks are keeping you awake then it is a problem.

263 posts
bio
Was this reply useful? Learn more...
   
[-]
Ruby +0 points · about 5 years ago Sleep Commentator

There is a part that is on the connection between the hose and the mask like a diffuser. It lets air out of the mask. Is this a new mask? My old mask had a diffuser that allowed the air to push out fairly hard. My husband often complained about it hitting him and there were times when I could feel it on my own face. I have a new diffuser that helps with that. You can barely feel the air coming out of it now. This might not have anything to do with your issue but thought I would let you know.

19 posts
Was this reply useful? Learn more...
   
[-]
wandafeb02 +0 points · about 5 years ago Original Poster

Thank you. It's when the pressure gets stronger and it's coming from the nasal part and sometimes the sides.

209 posts
bio
Was this reply useful? Learn more...
   
[-]
bonjour +0 points · about 5 years ago Sleep Commentator

This is an area Sleepyhead is very good at. If Sleepyhead shows a LL or Large Leak you have something that should be addressed because that could be impacting your therapy. https://www.apneaboard.com/sleepyhead/ to download SLeepyhead

95 posts
bio
Was this reply useful? Learn more...
   
[-]
dmypub +0 points · about 5 years ago

I can control the nasal leaks on my F30 by tightening the strap on top of the head. I have not been able to control small leaking due to the pressure I need, which is 16 - 17 cm. Any time I move in the slightest, then any area around my mouth will start flapping. I can stop these leaks only if I tighten all straps beyond reasonable comfort. I backed off on the straps and have managed to reduce leaks by holding my hand on the mask. Whenever I feel the mask start to flap, I just give the mask a slight push - it seals again. To better deal with this, I am going to test a couple liners. I also bought a mouthguard to better hold my mouth shut - mouth opening definitely causes leaking. I tried taping, and it works, but the tape I bought, which was a 3m micropore tape - is a pain to take off in the morning, and sometimes it peels off my top lip layer. Yikes !

Please be advised that these posts may contain sensitive material or unsolicited medical advice. MyApnea does not endorse the content of these posts. The information provided on this site is not intended nor recommended as a substitute for advice from a health care professional who has evaluated you.