We use cookies and other tools to enhance your experience on our website and to analyze our web traffic.
For more information about these cookies and the data collected, please refer to our Privacy Policy.

AirFitP30i cleaning

74 posts
bio
Was this reply useful? Learn more...
   
[-]
Sleepea +0 points · almost 3 years ago Original Poster

I just started using this mask a few weeks ago, and I am enjoying it. When I was cleaning the pillows I removed the defuser.

I came across this ResMed video and they don't remove the defuser. I would think if the cotton/fabric inside the part was wet, it would cause problems. https://www.youtube.com/watch?v=xEHEMrFwsGg

Should I be removing the defuser? It is very simple to remove, and simple to reassemble. I am sure I saw a video or pictures of the defuser being removed for cleaning.

3,259 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · almost 3 years ago Sleep Patron

The manual says to soak in soap and water, and then let it air dry. It would seem that water will not harm it. See page 4 in the manual at the link below.

P30i Manual

74 posts
bio
Was this reply useful? Learn more...
   
[-]
Sleepea +0 points · almost 3 years ago Original Poster

Thank you.
That is where I saw it, I looked over the manual but didn't see it until you mentioned page four. Page four shows it being removed.

I wouldn't think getting the fabric wet would be good. Having the vent removed would speed up drying time as well.

3,259 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · almost 3 years ago Sleep Patron

I kind of think the opposite. A mask is going to be exposed to the moisture in your breath for 8 hours a night. It has to be made to take that, and if anything washing it should be good for it. I suspect it comes out so you can clean it better.

74 posts
bio
Was this reply useful? Learn more...
   
[-]
Sleepea +0 points · almost 3 years ago Original Poster

That makes sense. I would always remove the stand-alone filter on my other masks. I never tried washing the filter, I would replace it. This filter is inside a casing, so I would think it wouldn't dry as quickly inside the case.

I will try washing it when I am ready to replace the cushion.

3,259 posts
bio
Was this reply useful? Learn more...
   
[-]
Sierra +0 points · almost 3 years ago Sleep Patron

Neither my wife or I have used this mask. My wife has a F&P Brevida that has a "filter" somewhat like this. She just washes it along with the mask. I believe it is not really a filter, but is for air velocity reduction to suppress noise.

74 posts
bio
Was this reply useful? Learn more...
   
[-]
Sleepea +0 points · almost 3 years ago Original Poster

I asked ResMed, they replied:

Yes, the QuietAir vent you're referring to is designed to be washed and cleaned as a part of the mask/pillow components, exactly as outlined in the video and your user guide: rinse, soft bristle brush cleaning, air dry out of direct sunlight.

So, I shouldn't be removing it before cleaning. Tomorrow morning I will clean the "filter" with the cushion. I will see how well it dries before I use it tomorrow night.

Please be advised that these posts may contain sensitive material or unsolicited medical advice. MyApnea does not endorse the content of these posts. The information provided on this site is not intended nor recommended as a substitute for advice from a health care professional who has evaluated you.